The ‘Infinity’ Motor/Generator

 

Infinity Motor/Generator

Magnetically coupled planetary gear, a wheel within a wheel, a swirling double vortex.
This flips the generator equation 180 degrees. Question: What can be achieved by pulling the
electricity through the coil instead of pushing? Its the difference between your car spinning
its wheels taking off or slamming the brakes and have to restart.

Conventional generator setup:
An electric motor turning an electric generator, the motor consumes electricity while turning the generator. When current is drawn from the generator it takes increasing amounts of electricity to turn the drive motor. As more current is drawn, the lenz forces increases and the motor can reach its maximum output, slow and stop all due to lenz force.

Infinity Generator Difference:
On the Infinity generator, same size electric motors spinning magnets over coils, producing current and also creating lenz law forces. This force that can stop a conventional generator, propels the main rotor forward. As a load is placed on Infinity, the main rotor speeds up and is limited only by the mass of the rotor, the power of the motor and the friction in the bearings. As you pull current from the attached conventional generator and lenz law force slows it down, at that time the Infinity generator motors increase in torque and power output increases, thus producing more lenz force pushing the main shaft forward, adding more torque onto the main shaft and driving the device ever faster forward. As the motors reach their maximum output the onboard controler balances the output power of Infinity, conventional generator and motors for optimum efficiency.

Point: ‘Now’ you can control the speed of a generator while you are pulling current.

Question: In a conventional generator design, lenz force slowing and stopping the rotor is inevitable. Could more current be available from a generator if lenz force was controllable? We need to find out what is on the other side of the Lenz force equation. What are the possibilities
of a generator, that when loaded, spins faster and faster instead of slower and slower?

ALSO: On the Infinity side you have a ‘leverage effect’ of using the larger diameter rotor to turn the smaller diameter conventional generator.
You could have a 36-inch rotor turning a low speed permanent magnet alternator (wind generator type). That could possibly be enough to supply
itself?

Post to Twitter

Comments (0)

Track comments via RSS feed!
Trackback URL for this Entry: http://FreeEnergy.TV/magnet-motors-2/the-infinity-motorgenerator/trackback/

Add comment